SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 10 of 10
3 years ago
Joel Kunz
Wasn’t aware of a video. I’ll check it out and will definitely look into the G2 components. Appreciate it.
Forum: rodboard 3 years ago
Joel Kunz
Anyone have any ideas how to finish off these grips? Not a fan of the small foam pieces that they include with the grips. Thinking of making some pieces out of cork. Thanks
Forum: rodboard 4 years ago
Joel Kunz
X4 I have never had a Fuji guide fail ever. I think they have the best fit, finish, and corrosion resistance as well. Have used a few Alps as well and have been pleased with these too.
Forum: rodboard 6 years ago
Joel Kunz
Roger,
I sent them an email last night. Hope to hear from them early next week. Talked to a guy there yesterday about the roller situation. He was trying to locate some larger rollers. If I don’t hear back from him, I’ll call in a few days.
Forum: rodboard 6 years ago
Joel Kunz
After building my first rod with this wrapper, I applied threadmaster using the dryer setup on this unit. I went downstairs after about 4 hours drying time to shut it down. I noticed the rod wasn’t turning. Here the dryer motor shaft with the pulleys attached to it literally fell out of the motor. Had to strip some of the rod due to the finish sagging and redo, and lost the rod decal in the proce
Forum: rodboard 6 years ago
Joel Kunz
Looking for some ball bearing rollers 1.25 to 1.5 inches in diameter. It’s for an Alps wrapper. Thanks
Forum: rodboard 6 years ago
Joel Kunz
As per your suggestion Grant, I just got off the phone with Batson and their trying to locate me some larger rollers. Thanks
Thanks Roger for going above and beyond. I viewed your setup. Wow is all I can say. Nice
Forum: rodboard 6 years ago
Joel Kunz
Thanks for all the comments. But I believe Gary is spot on. The spring loaded upper arms are useless.
Forum: rodboard 6 years ago
Joel Kunz
I’m in the process of wrapping my first rod using this wrapper. The upper rollers on both of the spring loaded rod supports make no contact with the blank. Hence the blank just rests on the two lower rollers. Are there any alterations that can be made to have those upper rollers hold the blank in place. I don’t see myself wrapping any rods thick enough for these rollers to work with the current s
Forum: rodboard
Current Page: 1 of 1
|