SPONSORS
2024 ICRBE EXPO |
carbon fiber grips
Posted by:
Bill Sidney
(---.gci.net)
Date: April 20, 2018 06:52PM
I received 2 carbon fiber grips from A supplier , an they look like there should be some type of coating on the fiber ?? they feel good, but I am a little worried about the dirt /sand/ fish scales
getting into the weave , should I forget it, an install ? or apply A coat or 2 with some Perma Gloss [ make smooth an look great ] I don't know , any help the weave is tight to the foam , no air under the fiber/weave , any input William Sidney AK Edited 2 time(s). Last edit at 04/20/2018 06:54PM by Bill Sidney. Re: carbon fiber grips
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: April 20, 2018 08:36PM
Top coat with Permagloss, very easy to do and looks great. Here is a video by Tom on how to do it. If you don’t have a lathe use a cordless drill.
[m.youtube.com] Norm Re: carbon fiber grips
Posted by:
Mark Hahn
(---.85.91.75.dynamic.ip.windstream.net)
Date: April 23, 2018 01:54PM
Bill, I had the same question and Norman Miller gave me the same advice he listed above. I followed his instructions and never regretted it. Re: carbon fiber grips
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: April 23, 2018 04:31PM
Thanks Mark!
Norm Re: carbon fiber grips
Posted by:
Bill Sidney
(---.gci.net)
Date: April 24, 2018 09:05PM
it is in the mail as I type from a sponsor on the right , thanks Norman for the pointers William Sidney AK Sorry, only registered users may post in this forum.
|