SPONSORS
2024 ICRBE EXPO |
Tiger
Posted by:
Jeff Mayfield
(---.sub-174-222-5.myvzw.com)
Date: October 22, 2017 04:56PM
I am going to try a tiger wrap for the first time. I am not clear on the placement of the thread that will be removed. Was hoping for a gold and black combination. Can anyone give me some of the expert advice from this forum?
Thank you all for this great site and advice. Re: Tiger
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: October 22, 2017 05:45PM
Did you read the article in the library (above), it is very comprehensive. Re: Tiger
Posted by:
Grant Darby
(---.wavecable.com)
Date: October 23, 2017 03:28PM
Gold and black under, wrapped up the blank. Burnish, 2 coats of finish. Black and some other color over, wrapped down the blank. Remove the "other" carefully. That's about as simple as it can be made. Lots of variations of each step are available. Re: Tiger
Posted by:
Taylor Belinger
(---.se.biz.rr.com)
Date: October 25, 2017 05:16PM
Hey Jeff,
This could help a little, we did a blog on tiger wraps a few months ago, Check it out: [blog.mudhole.com] Hope it helps! Sorry, only registered users may post in this forum.
|