SPONSORS
2024 ICRBE EXPO |
Winn Grips for SK2
Posted by:
doug raff
(---.lightspeed.tukrga.sbcglobal.net)
Date: March 22, 2017 05:24PM
I'd like to build a matched set of casting rods using the Fuji SK2 reel seat and Winn Grips.
Unfortunately, I've not been able to find properly sized grips in basic black. M.H., A.W. and G.B.O. have grips made for the SK2 but either are the wrong color or don't seem to come in a 3.5-4" rear grip. Does any one: 1. Know of a source of a properly sized casting rear grip? 2. Or had experience shaping a larger diameter Winn Grip to a SK2 seat? Thanks, Doug Re: Winn Grips for SK2
Posted by:
Norman Miller
(---.lightspeed.jcsnms.sbcglobal.net)
Date: March 23, 2017 12:04AM
The best Winn grip that I have found that fits the SK2 casting reel seats are the MHX Winn grips they are the right length and diameter, but are not basic black. The Fuji SK2 Winn grips are too short and the diameter too small. If you like a split reel seat you may want to substitute the PacBay minima casting seat for the SK2 seat. All of the other Winn casting grips will fit the Minima seat so you have a larger selection to chose from, plus it's a real nice reel seat, and all of the SK2 parts fit it.
Norm Re: Winn Grips for SK2
Posted by:
Tom Wewerka
(---.bltmmd.fios.verizon.net)
Date: March 23, 2017 08:26AM
Doug there are Winn grips especially made for the Fuji SK2 grips. IN the link below one of our Sponsors Get Bit Outdoors has them. Either click on the link or go to Get bit under components look for Fuji in the Winn grip section.
Tom [www.getbitoutdoors.com] Re: Winn Grips for SK2
Posted by:
doug raff
(---.lightspeed.tukrga.sbcglobal.net)
Date: March 23, 2017 08:15PM
Unfortunately the SK2 casting rear grip Get Bit Outdoors carries is only 2.5". If only it were an inch longer! Sorry, only registered users may post in this forum.
|