SPONSORS
2024 ICRBE EXPO |
Re: Finesse Spinning Rod
Posted by:
Mark Hogquist
(---.spok.qwest.net)
Date: March 21, 2017 02:33AM
Put it this way. The P843 high mod makes a killer finesse rod. The SJ842 makes a killer "power finesse" rod. Re: Finesse Spinning Rod
Posted by:
Michael Danek
(---.adr02.mskg.mi.frontiernet.net)
Date: March 21, 2017 09:45AM
Ben, regarding the ramps I use off the front of the uplocking seat, the photos below are typical of them. Usually I make them out of rigid polyurethane reel seat shims and put 3 coats of wrap epoxy over them. Keep the diameter just smaller than the hood diameter to make running the wrap epoxy up to the seat hood easy. If the ramp is bigger than the hood diameter, it is very difficult to get the finish into the joint without getting it on the hood. Also, the diameter of the ramp, being essentially the same size as the hood, makes for very good ergonomics. Burl cork is good for these ramps, too. It's harder, tougher, smoother, than regular cork.
[www.rodbuilding.org] [www.rodbuilding.org] Re: Finesse Spinning Rod
Posted by:
Ben Eipert
(157.89.235.---)
Date: March 21, 2017 01:59PM
Mark thanks for the clarification. That makes a lot of sense. It sounds like the SJ 842 is what I need Michael thanks for the info on the Ramps Edited 1 time(s). Last edit at 03/21/2017 02:01PM by Ben Eipert. Sorry, only registered users may post in this forum.
|