SPONSORS
2024 ICRBE EXPO |
Need some advise!
Posted by:
Larry Berkovsky
(---.cnrocmta03.res.dyn.suddenlink.net)
Date: February 13, 2017 10:15PM
Put the first coat of epoxy on my son's rod this weekend which included a small portion of the blank for the label. After letting the epoxy cure for a day I applied the "peel and stick" label to a pretty decent looking first coat. Initially the label looked great. Now after a day it looks like crap with lots of patches of where it was no longer sticking. I can't press them out or poke tiny hole to get the air out. So instead of proceeding to put the 2nd coat on, I yanked the label off. Now I have a patch of tacky adhesive on a coat of epoxy. At least now a have a learning curve dilemma instead of a crappy looking label. Any thoughts on how to get the adhesive off?
Thanks for all the help in advance. Re: Need some advise!
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: February 13, 2017 10:34PM
Goo Gone Re: Need some advise!
Posted by:
Matthew Pitrowski
(---.lightspeed.milwwi.sbcglobal.net)
Date: February 14, 2017 03:19AM
pure rubbing or denatured alcohol The best day to be alive is always tomorrow !! Think out side the box when all else fails !!! Wi. Re: Need some advise!
Posted by:
Donald R Campbell
(---.socal.res.rr.com)
Date: February 14, 2017 12:14PM Re: Need some advise!
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: February 14, 2017 05:10PM
Neither types of alcohol will dissolve the decal adhesive. Re: Need some advise!
Posted by:
Larry Berkovsky
(12.252.36.---)
Date: February 14, 2017 05:29PM
Phil, I started up with some Goo Gone last night. I think it might do the trick w/o taking the epoxy with it. Thanks. I also have some Goof Off but I'm going to hold off on it. I think it has xylene which might play heck on the epoxy.
Gents, I thank you for your direction and assistance. Re: Need some advise!
Posted by:
Dennis Danku
(---.dyn.optonline.net)
Date: February 15, 2017 12:47PM
Good old Ronson lighter Fluid. Dennis J. Danku (Sayreville,NJ) Re: Need some advise!
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: February 15, 2017 03:20PM
Lighter fluid that Dennis suggests will work fine - as will any other mineral spirits or thinner. But, because these materials leave their own residue behind, Clean that residue off with a cleaner, like simple green, or windex. If you don't clean, the mineral spirits residue left behind will cause final finish adhesion.
Be safe Re: Need some advise!
Posted by:
Dennis Danku
(---.dyn.optonline.net)
Date: February 15, 2017 06:45PM
Or orange peel and fish eyes. Dennis J. Danku (Sayreville,NJ) Sorry, only registered users may post in this forum.
|