SPONSORS
2024 ICRBE EXPO |
How To Engrave Natural Cork Handles
Posted by:
Lam Nguyen
(162.119.11.---)
Date: August 15, 2016 05:46PM
I have been looking into building a natural cork handle with a fish engraving and ran across a few very nice examples while doing my search online. I have built a couple of rod handles with engravings in the past. I would use an x acto knife to carve the image in the natural cork handle then glue thin slices of burnt burl corks and fine lathe the handles down.
While doing my search online I ran across a website that has a picture of a bunch of rod handles with very intricate engravings. Plese see attached link below. I was just curious how they did this. Thanks in advance! [www.google.com] Re: How To Engrave Natural Cork Handles
Posted by:
Tom Kirkman
(Moderator)
Date: August 15, 2016 05:54PM
If I'm looking at the correct photos, I believe those are "burned" onto the cork - pyrography.
............. Re: How To Engrave Natural Cork Handles
Posted by:
Lam Nguyen
(162.119.11.---)
Date: August 15, 2016 06:31PM
Thanks Tom! Oh boy....another technique for me to learn......Thanks again! Re: How To Engrave Natural Cork Handles
Posted by:
Jay Dubay
(---.try.wideopenwest.com)
Date: August 16, 2016 10:12PM
Those were done with a laser here is some more examples. [www.etsy.com] Re: How To Engrave Natural Cork Handles
Posted by:
John E Powell
(---.dynamic.wnyric.org)
Date: August 31, 2016 11:54AM
Comments deleted Edited 1 time(s). Last edit at 09/20/2016 04:07PM by John E Powell. Sorry, only registered users may post in this forum.
|