SPONSORS
2024 ICRBE EXPO |
Information on the preparation and use of Fuji and Toray resins
Posted by:
Eliseu Cherene
(---.petrobras.com.br)
Date: May 21, 2016 11:05PM Re: Information on the preparation and use of Fuji and Toray resins
Posted by:
Tom Kirkman
(Moderator)
Date: May 22, 2016 07:52AM
I think you'll do a lot better with a much wider brush. The work will go a lot more quickly as well. Epoxy finishes are casting resins, not paint, and therefore are better "spread" on the surface than dabbed or dappled.
............... Re: Information on the preparation and use of Fuji and Toray resins
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: May 22, 2016 11:20AM
10-4 Tom
With a 1 inch wide brush and a blank that was spinning at about 60 rpm, the finish could be applied in about 15 seconds, rather than the time shown in the video with equal or better results. Be safe Re: Information on the preparation and use of Fuji and Toray resins
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: May 22, 2016 12:20PM
Yep
Time is money Plus the faster turning will help with straighter lines on finish ends Bill - willierods.com Sorry, only registered users may post in this forum.
|