SPONSORS
2024 ICRBE EXPO |
Recoil micro
Posted by:
David Bourque
(---.dynamic.eatel.net)
Date: May 01, 2016 10:18PM
I recently built 2 rods with recoil micros. I was a little nervous at first. Once the builds were complete I put a lot of load on the rod and rolled it back in forth to see if they would move or even lay flat. They held up nice no bending like I thought I would see.I know some folks hate them because of the noise but has any body had major failure? These rods were heavy casting blanks. So far so good no complaints. Has any one had major issues working with them or is it really just personal opinions? Re: Recoil micro
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: May 01, 2016 11:02PM
I have them on a CTS travel spinning rod for quite a few years now with no issues, I don't think the fish mind the noise. Sorry, only registered users may post in this forum.
|