SPONSORS
2024 ICRBE EXPO |
Rod dryer
Posted by:
Paul James Vonderwall
(---.pa.vic.optusnet.com.au)
Date: November 20, 2015 08:10AM
Hi guys new on this site just wandering if you can
Help I have single rod dryer but have lot of To go on but I need to make wall mount For four. Rod to go on something like flex coat One now if brought a flex coat 4x18 I still have To change the motors over to 240v power For Australia hope you can help Re: Rod dryer
Posted by:
Capt Neil Faulkner
(---.dyn.optonline.net)
Date: November 20, 2015 08:21AM
Hi,
I would call Flex Coat and ask if they can install the motors you need before shipping it to you. I have been using their 4x18 for many years of hard service. Capt Neil Faulkner Re: Rod dryer
Posted by:
Paul James Vonderwall
(---.pa.vic.optusnet.com.au)
Date: November 20, 2015 08:36AM
Thanks pal I email as I am in South Australia Re: Rod dryer
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: November 20, 2015 12:41PM
Paul,
Another way to go is with a drum dryer. A unit like this uses a singe motor and may dry up to a dozen rods at a time. Basically a couple of drums mounted on a center shaft, supported on one end with a bearing in a stand and the other end driven by an appropriate motor. These are pictures that came up when one does a search on the photo forum for "drum dryer". [www.rodbuilding.org] Edited 1 time(s). Last edit at 11/20/2015 12:47PM by roger wilson. Sorry, only registered users may post in this forum.
|