SPONSORS
2024 ICRBE EXPO |
Removing dried epoxy from EVA
Posted by:
Alistair Mangion
(---.access.maltanet.net)
Date: October 09, 2015 01:52PM
I had some epoxy (the one used for gluing components) paste run and drying up on Eva foam grip. What is the best way to clean it up ? Is it ok to finely sand the Eva ? Re: Removing dried epoxy from EVA
Posted by:
Scott Hovanec
(---.sub-70-199-8.myvzw.com)
Date: October 09, 2015 03:15PM
Sanding will be fine. Use a sanding block so you remove the hardened epoxy and surrounding EVA equally.
If you would try to pull off the epoxy, you will take chunks of EVA too. Re: Removing dried epoxy from EVA
Posted by:
bill boettcher
(---.nwrknj.fios.verizon.net)
Date: October 11, 2015 05:49PM
If you can put it on a FAST turner and sand this will be better
If not hand sand carrefully around the area wher the epoxy is that will also work Working carrefully Masking any areas where you don't want any scratches Bill - willierods.com Sorry, only registered users may post in this forum.
|