SPONSORS
2024 ICRBE EXPO |
Rod marking pen
Posted by:
Adam Lathrop
(141.197.12.---)
Date: July 27, 2015 06:55AM
Might seem like a silly question but I was curious as to the answers out there. What does everyone seem to use for layout marks? There is the obvious grease pen but that is a little course when laying out marks for chevrons and the like. What has everyone found to work well and not leave to much of a mark so that it doesn't show after a wrap is complete. Re: Rod marking pen
Posted by:
Tom Kirkman
(Moderator)
Date: July 27, 2015 07:45AM
I mark a section of white NCP thread and then tape that in place. After a few crosses are done, the thread is snipped at either end and pulled out from under the wrapping threads.
................... Re: Rod marking pen
Posted by:
Adam Lathrop
(141.197.12.---)
Date: July 28, 2015 07:27AM
Does anyone use like a scratch awl or somthing to scratch a tiny mark on the blank? Re: Rod marking pen
Posted by:
Tom Kirkman
(Moderator)
Date: July 28, 2015 12:14PM
Some do, just be careful not to scratch too deep.
...... Sorry, only registered users may post in this forum.
|