I would like to thank everyone that gave me some ideas. I am sure I will make a few changes.
Here is what I have:
8 foot rod wrapper
Seperate area for drying handle
Seperate area for mixing epoxy
I know gave a lathe for turning rod handles and that is set up in the garage.
The lathe bench is portable to take the dust outside.
4-4 foot lights with daylight bulbs for plenty of good light.
Cabinets to keep my guides and stuff organized.
Bucket with PVC to organize ice fishing blanks.

I will try to post pictures.

Now it us time to get to work.

Good day, Doug

See you on the water, Doug
Captain Paddlefoot

Tried to put pictures on couldn't.

Message said to log in but, I am.

When I tried to log on on the photo page, it said invalid.

Tom can you help?

Good Day, Doug

See you on the water, Doug
Captain Paddlefoot

Did you use the same log in as you used here ??

Bill - willierods.com

Yes

See you on the water, Doug
Captain Paddlefoot

I registered on there and the pictures are loaded.

Thanks Bill

See you on the water, Doug
Captain Paddlefoot

Doug,
Great looking work on your shop.

I see that you have a chop saw under your lathe.

If you pick up an abrasive cut off wheel, and replace the blade on your chop saw with it, you will have a great tool for trimming blanks, cutting arbors, etc.

[www.homedepot.com]

The wheels from Grainger - "abrasive tool room cut off wheel" is a much better wheel, since it is only .060 thick. This thinner wheel makes a very clean cut and wastes less material on the cut.

[www.grainger.com]$

Doug,
This was one of the first "chop saws" that I modified for chopping blanks and other materials.
Since an abrasive wheel wears down over time, I elevated the cutting surface by installing a 2X4 channel on the bed. Then, I installed a piece of stock just behind the center line of the saw wheel to use as a back plate for cutting.

After installing, just ran the saw down through the materials to make a thin clean cut for a nice tight fit and no issues about material falling into a hole in the saw.

I happened to pick up this saw used at a used tool shop for $20. This has one of the Grainger "tool room cut off wheels" installed on it.
By the way, I have cut all materials on this saw, graphite, steel, aluminum, brass etc. etc.

[www.rodbuilding.org]

I added the halogen light for great viewing when using the saw.

Be safe