SPONSORS
2024 ICRBE EXPO |
HPS Lock Nut
Posted by:
steve george
(---.lightspeed.dybhfl.sbcglobal.net)
Date: October 23, 2014 11:47AM
Has anyone tried putting more rings on a Fuji HPS lock nut? I know that 4 will fit but there is more bit shank that a 5th ring might be supported by with a good glue up. Re: HPS Lock Nut
Posted by:
Jim Ising
(---.dyn.centurytel.net)
Date: October 23, 2014 03:45PM
Can you cut the ring in half with a cork cutting jig? Or you could always order the cork made for it...FGH25C (for a 16), FGH27C (for a 17) Re: HPS Lock Nut
Posted by:
Tony Hill
(---.sub-75-197-86.myvzw.com)
Date: October 24, 2014 01:38AM
I usually use the one made for it. Have also used a 4" foregrip, bored out to fit. I tapered it so it looked pretty much like the factory cork, just a little longer.
To be honest, I have to look to which rod is which to tell the difference. Both work just fine. IF you put an extra ring on it, it won't hurt. Bore the lower ones to fit the HPS nut body, then bore the extra one to fit the blank. It will work just fine. -Tony Re: HPS Lock Nut
Posted by:
steve george
(---.lightspeed.dybhfl.sbcglobal.net)
Date: October 24, 2014 08:02PM
Thanks for the help. Sorry, only registered users may post in this forum.
|