SPONSORS
2024 ICRBE EXPO |
SpinJig bank for casting rod
Posted by:
Glenn McMurrian
(184.11.138.---)
Date: September 15, 2014 03:57PM
This guy wants a 6.6 MHX rod for fishing 40 ft or water for trout,so my problem is that MH is to heavy for trout and a Med rod is kind of in the middle and a Lite power rod is to lite for fishing that deep. I did find one MHX blank in the Med/lite power but it is a spin jig rod blank and this will be a casting rod so will a spin jig blank work just the same as it needs to have a bit of power also for a hook set and not to lite or under powered so any help guys as this is sort of like punting against the wind. Glenn McMurrian Re: SpinJig bank for casting rod
Posted by:
Tom Kirkman
(Moderator)
Date: September 15, 2014 04:13PM
Disregard the category listing and go by the specs of the blank. It if appears to have the power and action you're after, then yes, it will work just fine.
............. Re: SpinJig bank for casting rod
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: September 15, 2014 08:56PM Re: SpinJig bank for casting rod
Posted by:
Chester Kiekhafer
(---.mpls.qwest.net)
Date: September 15, 2014 11:20PM
roger wilson Wrote:
------------------------------------------------------- > [www.laketrout.org] > anoe.htm Nice video Sorry, only registered users may post in this forum.
|